[ad_1]
“I always make sure that the car I drive is in good technical condition, so I am not too concerned about the date of the roadworthiness test. However, recent experience has shown that if there are no technical failures, it does not mean that the car can be recognized as technically in order, “said the girl who wrote for Delfi’s writing.
The girl who drove to have her Honda Accord inspected noticed that her car had been inspected the longest throughout the inspection station. During the time the driver inspected his car, his colleague managed to inspect three others.
“It became even more interesting when it was concluded that the car did not meet the technical requirements, because how big the defect of the excessive wheels of the car was,” said a Delfi reader about the blink of an eye and the negative conclusion of technical inspection.
According to her, Honda is equipped with R18 diameter rims with tires and its dimensions are 225/40. As the girl said, when choosing the rims and tires, she took into account that the overall wheel size would not be larger than the manufacturer had predicted: in other words, a larger rim but more profile tires. low.
“It just came to our knowledge then. However, it turns out that this is a major drawback that can make the car technically considered messy. The driver explained that the largest possible wheels for my car are R17, so R18 is already a critical error ”, the interlocutor was surprised.
According to her, this was not the only defect that prevented the car from passing the roadworthiness test. Still, the fact that I didn’t like the rims surprised me more.
“This innovation has raised questions about whether sometimes it is not a deliberate attempt to ‘cut up’ a car so that the driver can visit inspection centers again and pay more for re-inspection,” he said.
Follow established requirements
Renaldas Gabartas, Communication Manager of the Association of Technical Inspection Companies “Transeksta”, highlighted that technical inspections are carried out in accordance with the established technical requirements and the controllers do not have the right to freely interpret them.
“In the case of automobile wheels, the technical requirements stipulate that the size and construction of the automobile wheels must be as specified by the vehicle manufacturer, and that the wheel parameters must be consistent with the parameters of the tire mounted on the wheel “.
According to him, on the basis of available databases and public data sources, it was established that in 2004 Honda Accord was equipped with wheels of size R15 or R16, depending on engine performance, but not R18. It is for this reason that car tires are considered a major drawback.
“The vehicle’s proper wheels and tires are an essential condition to ensure that the car steers (reacts to steering, brakes, etc.) as intended by the manufacturer,” Gabart said, adding that although there are formulas on the basis of which it can be calculated that the total size of the wheel does not exceed the intended manufacturer, the drivers try not to adhere to the solutions of mathematical problems, and the formally allowed deviation is 2%. sizes specified by the manufacturer.
It is strictly prohibited to use the information published by DELFI on other websites, in the media or elsewhere, or to distribute our material in any form without consent, and if consent has been obtained, it is necessary to cite DELFI as the source.
[ad_2]
